PM100 potential test terminal
Réf. DIP-197
PM100 renovation measurement point in stainless steel, to replace a plastic terminal or aluminium box on a Ø2" tube. 8VS plate, clip mounting without hardware, triangle lock.
Description
The secure PM100 renovation measurement point (potential test point) is made of stainless steel and combines the advantages of plastic, concrete or polyester models. It is used to replace a plastic terminal or an aluminium box installed on a Ø2" tube: rugged, easy cable access, simple installation, very low installation cost. From the PM100 range, it is closed by a removable cover locked with a triangle-type key.
It is fitted with an 8VS measurement plate (8 channels of 1 × 16 mm²) with gold-plated class III secure Ø4 mm banana sockets and protective caps, an 8-way 16 mm² connector, 6 gold Ø4 mm banana jumpers, an identification and wiring label, an Omega 7.5 DIN rail holding 7 terminals of 1 × 35 mm² IP21 (section adaptation), and a clip support allowing installation by a simple clip, without hardware.
Caractéristiques techniques
| Type | PM100 renovation measurement point (stainless steel) |
| Use | Replacing a plastic terminal / aluminium box on a Ø2" tube |
| Plate | 8VS – 8 channels 1 × 16 mm², gold class III Ø4 mm banana sockets |
| Terminal block | Omega 7.5 DIN rail, 7 terminals 1 × 35 mm² IP21 |
| Mounting | Clip support, no hardware |
| Closure | Triangle lock |
Documentation
Demande de prix
Ajoutez ce produit à votre demande et envoyez-la en une seule fois depuis le formulaire.
Documentation
A cathodic protection project?
Our engineers are at your disposal to study your requirements and propose custom-built solutions.
Réponse rapide
Sous 48h
Expertise certifiée
Ingénieurs NACE
Support continu
Maintenance 24/7